Ford and the assembly line

The mass-produced automobile is generally and correctly attributed to Henry Ford, but he was not alone in seeing the possibilities in a mass market. Ransom E. Olds made the first major bid for the mass market with a famous curved-dash Oldsmobile buggy in 1901. Although the first Oldsmobile was a popular car, it was too lightly built to withstand rough usage. The same defect applied to Olds's imitators.

Ford, more successful in realizing his dream of “a car for the great multitude,” designed his car first and then considered the problem of producing it cheaply.

The car was the so-called Model T, the best-known motor vehicle in history. It was built to be durable for service on the rough American country roads of that period, economical to operate, and easy to maintain and repair. It was first put on the market in 1908, and more than 15 million were built before it was discontinued in 1927.

When the design of the Model T proved successful, Ford and his associates turned to the problem of producing the car in large volume and at a low unit cost.

The solution was found in the moving assembly line, a method first tested in assembling magnetos. After more experimentation, in 1913 the Ford Motor Company displayed to the world the complete assembly-line mass production of motor vehicles. The technique consisted of two basic elements: a conveyor system and the limitation of each worker to a single repetitive task. Despite its deceptive simplicity, the technique required elaborate planning and synchronization.

The first Ford assembly line permitted only very minor variations in the basic model, a limitation that was compensated for by the low cost. The price of the Model T touring car dropped from $950 in 1909 to $360 in 1916 and still lower to an incredible $290 in 1926. By that time Ford was producing half of all the motor vehicles in the world.

II. Look through the text again and answer the following questions:

1. Who else (except Henry Ford) was in seeing the possibilities in a mass production of the automobile?

2. When was the first buggy introduced to the mass market?

3. Did Ford realize his dream of ”a car for the great multitude” or not?

4. Why did the Model T become so popular on the roads of that period?

5. Do you consider Ford the greatest car producer in the world? Why?

III. Match the words with their definitions and make up your own sentences with these words:

1. possibility a) not smooth, covered with scrub, boulders, etc.;

2. limitation b) a large mass or quantity;

3. volume c) to allow to do smth, to authorized, to let;

4. incredible d) any conveyance by which people are transported;

5. design e) to keep in proper or good condition;

6. to permit f) to show, to demonstrate or make visible;

7. vehicle g) some restriction of a quality or achievement;

8. to display h) a finished artistic or decorated creation;

9. rough i) improbable, inconceivable;

10. to maintain j) a future prospect or potential;

IV. Read the following statements and discuss them with a partner:

1. If the first Oldsmobile hadn’t been too lightly built it would have become a popular car.

2. The Model T became so popular on the roads of that period because of its economy and easy repairing.

3. The conveyor system of that period required elaborate planning and synchronization.

4. The first assembly line permitted minor variations in the basic model.

5. Due to the assembly line any person could permit himself to buy a car.

Giving your opinion you may find the following expressions helpful:

<== попередня сторінка	\|	наступна сторінка ==>
Make a short report in front of the class.	\|	By the way as for me I’d like to know

Не знайшли потрібну інформацію? Скористайтесь пошуком google:

Генерація сторінки за: 0.005 сек.