Text B. Transmission modes

Communication between two devices can occur in one of three ways: simplex, half-duplex, or full-duplex.

Simplex.

In simplex mode, the communication is unidirectional, as on a one-way street. Only one of the two devices on a link can transmit; the other can only receive.

Keyboards and traditional monitors are examples of simplex devices. The keyboard

can only introduce input; the monitor can only accept output. The simplex mode

can use the entire capacity of the channel to send data in one direction.

Half-Duplex.

In half-duplex mode, each station can both transmit and receive, but not at the same time. When one device is sending, the other can only receive, and vice versa. The half-duplex mode is like a one-lane road with traffic allowed in both directions.

When cars are traveling in one direction, cars going the other way must wait. In a

half-duplex transmission, the entire capacity of a channel is taken over by whichever of the two devices is transmitting at the time. Walkie-talkies and CB (citizens band) radios are both half-duplex systems.

The half-duplex mode is used in cases where there is no need for communication in both directions at the same time; the entire capacity of the channel can be utilized for each direction.

Full-Duplex.

In full-duplex mode (also called duplex), both stations can transmit and receive simultaneously. The full-duplex mode is like a two-way street with traffic flowing in both directions at the same time. In full-duplex mode, signals going in one direction share the capacity of the link with signals going in the other direction. This sharing can occur in two ways: Either the link must contain two physically separate transmission paths, one for sending and the other for receiving; or the capacity of the channel is divided between signals traveling in both directions. One common example of full-duplex communication is the telephone network. When two people are communicating by a telephone line, both can talk and listen at the same time.

The full-duplex mode is used when communication in both directions is required all the time. The capacity of the channel, however, must be divided between the two directions.

3.4 Answer the following questions:

1) What is the difference between half-duplex and full-duplex transmission modes?

2) Can you explain the word “walkie-talkie”?

3.5 Give some examples of simplex, half-duplex, full-duplex communication.

3.6 Write out key terms and expressions, use them to retell the text.

Читайте також:

<== попередня сторінка	\|	наступна сторінка ==>
Unit 3. Communication Systems and Networks	\|	Text C. Networks

Не знайшли потрібну інформацію? Скористайтесь пошуком google:

Генерація сторінки за: 0.003 сек.