• Гідрологія і Гідрометрія
• Господарське право
• Економіка будівництва
• Економіка природокористування
• Економічна теорія
• Земельне право
• Історія України
• Кримінально виконавче право
• Медична радіологія
• Методи аналізу
• Міжнародне приватне право
• Міжнародний маркетинг
• Основи екології
• Предмет Політологія
• Соціальне страхування
• Технічні засоби організації дорожнього руху
• Товарознавство продовольчих товарів

Exercise 25. Read and retell text.

Text 6.Antiskid System.

Maximum allowable braking for the condition of the runway is achieved with a modulating antiskid system that senses individual wheel speed during a stop and automatically controls brake pressure to each wheel.

The antiskid system optimizes braking by reducing brake pressure when the pilot or autobrake system commands pressure in excess of that required to skid the tires. The control unit analyzes wheel sensor inputs and sends appropriate signals to the antiskid valves which reduce the metered pressure supplied from the brake metering valves, or autobrake system. The system consists of four individual wheel speed transducers, one control unit, and six antiskid control valves (four normal and two alternate antiskid valves). Antiskid protection is provided for individual wheels in the NORMAL brake system and for pairs of wheels on the same landing gear through the alternative antiskid valves if hydraulic system В is inoperative.

The antiskid 'ON-OFF' switch is common to both normal and alternate braking systems. Turning the antiskid switch to 'OFF' turns off antiskid protection to all wheels and illuminates the 'ANTISKID INOP' light. If an antiskid system fault is detected during normal flight operations the 'ANTISKID INOP' light will illuminate reminding the pilots that full antiskid protection may not be available. The antiskid system contains self-test features.

Ground test features are built into the antiskid control unit for maintenance purposes. The antiskid control unit front panel includes antiskid system fault isolation provisions (normal and alternate), an autobrake test capability, and lights to assist in troubleshooting. Precise performance and calibration checks can be made through test receptacles located on the control unit.

Exercise 26. Find out the information on “Brake system”.

Exercise 27. Speak on the following topics.

1. The landing gear functions.

2. The main landing gear design.

3. The nose landing gear design.

4. Landing gear actuation.

5. Brake system.

6. Antiskid system.

UNIT 6. POWER PLANT

Читайте також:

1. Additional Exercise
2. Answer the questions on the text.
3. Ask ten questions to the text so that the answers became the retelling of the text.
4. Complete with the words from the text. Translate them into Ukrainian.
5. Context.
6. Exercise
7. Exercise 1
8. Exercise 1
9. EXERCISE 1
10. Exercise 1
11. Exercise 1
12. Exercise 1

Переглядів: 576