• Гідрологія і Гідрометрія
• Господарське право
• Економіка будівництва
• Економіка природокористування
• Економічна теорія
• Земельне право
• Історія України
• Кримінально виконавче право
• Медична радіологія
• Методи аналізу
• Міжнародне приватне право
• Міжнародний маркетинг
• Основи екології
• Предмет Політологія
• Соціальне страхування
• Технічні засоби організації дорожнього руху
• Товарознавство продовольчих товарів

Read and translate the text:

The spark plug must have an insulated passageway for high voltage to travel down to the electrode, where it can jump the gap and, from there, be conducted into the engine block and grounded. The plug also has to withstand the extreme heat and pressure inside the cylinder, and must be designed so that deposits from fuel additives do not build up on the plug.

Spark plugs use a ceramic insertto isolate the high voltage at the electrode, ensuring that the spark happens at the tip of the electrode and not anywhere else on the plug; this insert does double-duty by helping to burn off deposits. Ceramic is a fairly poor heat conductor, so the material gets quite hot during operation. This heat helps to burn off deposits from the electrode.

Some cars require a hot plug.This type of plug is designed with a ceramic insert that has a smaller contact area with the metal part of the plug. This reduces the heat transfer from the ceramic, making it run hotter and thus burn away more deposits. Cold plugsare designed with more contact area, so they run cooler.

The carmaker will select the right temperature plug for each car. Some cars with high-performance engines naturally generate more heat, so they need colder plugs. If the spark plug gets too hot, it could ignite the fuel before the spark fires; soit is important to stick with the right type of plug for your car.

HOT PLUGCOLD PLUG

Читайте також:

1. Complete with the words from the text. Translate them into Ukrainian.
2. Ex. 7. Translate into Ukrainian paying attention to the forms of the Gerund.
3. Exercise 1. Translate the following sentences paying attention to Participle Constructions in different syntactic functions.
4. I. Translate the following passage using the vocabulary of this lesson
5. I. Translate the following sentences into English
6. I. Translate the following sentences into English
7. I. Translate the following sentences into English
8. I. Translate the following sentences into English
9. III. Translate the following sentences using modal verbs
10. III. Translate the sentences below into English
11. III. Translate the sentences below into English using the infinitive or infinitive constructions
12. IV Analyze verb-forms and translate the following sentences. Match the verb-forms with their tenses in Active or Passive Voice.

Переглядів: 447